Ford Focus Forum, Ford Focus ST Forum - View Single Post - HOW-TO: SVT IMRC DSI Intake Manifold Upgrade FOR ZETEC!!!!
View Single Post
Old 12-30-2005, 10:41 AM   #36
sc0tty8
Focus Enthusiast
 
Join Date: Sep 2005
Fan#: 27536
Location: Litchfield MN
What I Drive: 2k3 Pitch Black ZX3

Posts: 104
FF Reputation: 1 sc0tty8 Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally posted by ztecpower
I just had an Idea...... You could have your chip turn the "Shift light" On the guages on at the Predeturmined 5000-5500 RPM's And hook a signal wire up to the light and then shoot it to a relay, switching on the DSI motor...... What would be wrong with that ? Plus it's cheaper and you don't have a box taking up space in the glove box.
What are your guys thoughts ?
So what your saying is that a PULSED (1 time 5v after pre deturmined RPM) Is sent to the DSI box to turn it on, And when it reaches Below the Pre deturmined RPM it again sends another 5v Pulse (1 time) ??
You can use resistors to accomplish the 5v but I don't know about the Momentary pulse.......

Troy.
I think the shift like is vacuum acuated. Besides, I don't want to tear into my dash.

I am interested in how v6focus did his, I know on the 4.2L v6, 3.8 v6, and, on the show, they used vacuum to change the runner legnths.

I am guessing a pulse activated/de-activated the runners, but, if your running 12v to the runners, the power source is on or off

I don't know, but, either way, I am going to do the swap.
sc0tty8 is offline  
    Reply With Quote