Focus Fanatics - View Single Post - Urethane vs. Fiberglass (Body/Lip Kits)
View Single Post
Old 09-07-2005, 07:26 PM   #6
Boogyman
Focus Rookie
 
Join Date: Oct 2004
Fan#: 14074
Location: Missouri
What I Drive: 2000 Blue zx3

Posts: 3
FF Reputation: 1 Boogyman Good Standing Member
Buy-Sell-Trade Rating: (0)
we fixed it. Made an exact plaster mold of the inside of the rear bumper We set it inside leaving about an inch clearance between the plaster and the inside walls with spacers. *3500lb epoxy held them fine, i was too sure how it would work but it did the job.* anyway then we filled the cavity with a superlightweight expanding liquid foam, put the pumper in our hot room. " wood heated room we have about 5x5 about 140 to 150F sometimes hotter. My mother uses the room to mold her wax blocks. but anyway. The heat softened the poly and the foam reformed it. Afterwards we let it cool down i stripped most of the foam out left in a little but not much waves were gone and now it looks good as new. Alot of work but it didnt cost me more then 20.00 for the plaster and 5.00 for the foam.
Boogyman is offline  
    Reply With Quote