Ford Focus Forum, Ford Focus ST Forum - View Single Post - p0352 code after coil,plugs, and wires
View Single Post
Old 02-15-2014, 12:14 PM   #1
oderus1671
Focus Rookie
 
Join Date: Jan 2013
Fan#: 107936
Location: roper, NC
What I Drive: 2003 silver 4 door focus

Posts: 11
FF Reputation: 1 oderus1671 Good Standing Member
Buy-Sell-Trade Rating: (0)
p0352 code after coil,plugs, and wires

Hey all, I have a 2003 Focus SE with a 2.0 vin "p", 230K miles. It was running rough, bucking at low rpms while driving at highway speed, so I did a tune up. New coil pack, new wires, and plugs. Gapped the plugs to the spec on the sticker in the engine compartment. Now, it barely runs without stalling, and is kicking up p0352 code, and cylinder 1 misfire code. It was just running rough at first, but then kicked up a cylinder 1 misfire code, nothing else, so i figured it to be ignition. Ive triple checked the wires are on the correct coil post. The plug harness going into the coil appears fine, no cracked or loose wires. Im at a loss here. Any ideas?


oderus1671 is offline  
    Reply With Quote