Ford Focus Forum, Ford Focus ST Forum - View Single Post - Opinions on header wrap for svt header?
View Single Post
Old 08-29-2013, 11:42 PM   #11
homelessmonkey
Focus Enthusiast
 
homelessmonkey's Avatar
 
Join Date: May 2012
Fan#: 98498
Location: Ottawa,ON, Canada
What I Drive: 2003 black zx3

Posts: 150
Points 787, Level 14
Points: 787, Level: 14 Points: 787, Level: 14 Points: 787, Level: 14
Level Up 87% Completed
Level up: 87% Level up: 87% Level up: 87%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 2 homelessmonkey Good Standing Member
Buy-Sell-Trade Rating: (3)
I wrapped my svt header with a roll of 2inx50ft dei titanium had about 6ft left, keeps the engine temp down and you don't need to seal it.

What I did was wrap one tube then measure how much I used for that tube, then cut 4 strips that length with 1 inch more and then you have like 20 ft left for the bottom.

Just make sure you have your bung welded in before you wrap it(or have a delete for the egr) I made that mistake, I only realized after I was done and I had to re-wrap it and then the wrap was starting to fall apart so don't play with it too much.

http://www.focusfanatics.com/forum/showthread.php?t=316481
homelessmonkey is offline  
    Reply With Quote