Focus Fanatics - View Single Post - "How To" - Fans Mod
View Single Post
Old 03-14-2005, 05:22 PM   #2
W~Phoenix~{RC}
FF Bouncer
 
W~Phoenix~{RC}'s Avatar
 
Join Date: Aug 2004
Fan#: 11450
Location: Cedar Rapids, Iowa
What I Drive: 2003 Silver Frost Sport Edition ATX

Posts: 3,178
FF Reputation: 1 W~Phoenix~{RC} Good Standing Member
Buy-Sell-Trade Rating: (29)
3) Take your ~10” Gauge 10 Copper Wire and strip off about a Ό” from each end and crimp on the Male Terminal Disconnects.


4) This is how the wire should look when you are done crimping.


5) Cut the plastic sleeve off of one of the Male Terminal Disconnects on one side and crimp it a couple more times so that it will be as flat as it can be. You need to do this because it’ll be easier for the wire to fit in with Fuse F1.
__________________
Brad - FFR Moderator
Dyno Results † Exhaust Clip † ROTM Showcase
Information Archives † Vote: August ROTM † Vote: FF ROTY
W~Phoenix~{RC} is offline