Focus Fanatics - View Single Post - Head Work.
Thread: Head Work.
View Single Post
Old 04-02-2013, 06:04 PM   #20
thejordan
Focus Addict
 
thejordan's Avatar
 
Join Date: Dec 2012
Fan#: 107706
Location: Southern, CA
What I Drive: 2013 SGM Focus 5 Speed

Posts: 617
FF Reputation: 3 thejordan Good Standing Member
Buy-Sell-Trade Rating: (1)
Quote:
Originally Posted by RedVAhb757 View Post
I bought it used & a lot cheaper than a new MK3 would have been I saved about 5k. How bout porting the exhaust & intake ports on the head? Just figured if you put a CAI, header & exhaust on this would help easily break the 200hp barrier.
As I originally recommended, port and polish both intake and exhaust manifolds, coat the exhaust side too, that will help. Remove the butterfly valves too.

Quote:
Originally Posted by jdubhack View Post
At 200 HP you're going to be pushing the limits of the DCT.
Fusion is 230hp stock on the DCT, so not really. But then again, the DCT doesn't seem to be sensitive as is.

Quote:
Originally Posted by jdubhack View Post
Header install, 3" exhaust, AEM intake and your looking @ 193 WHP. That's the furthest anyone has pushed the DCT.
Quote:
Originally Posted by RedComet View Post
Who was this? I thought Focusboy58's 183ish whp was the top of the pile. That's pretty cool.
193 and 183 differences on the same dyno or different dynos? Did they do a baseline (stock)? Otherwise apples-oranges.

It depends on the cams Gabe went with, I'm guessing for top-end, in which an exhaust that big would help near redline.
thejordan is online now  
    Reply With Quote