Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - FSWerks Cool-Flo Intake Installation Problems
View Single Post
Old 04-02-2013, 07:49 AM   #88
QuickSiR
Focus Rookie
 
Join Date: Jan 2013
Fan#: 108256
Location: Rigaud, Canada
What I Drive: 2009 Focus SE

Posts: 7
FF Reputation: 1 QuickSiR Good Standing Member
Buy-Sell-Trade Rating: (0)
Well, last saturday it was finally nice enough outside to be able to install the FSWERKS intake on my 2009 Focus SE.

I experienced every single problem the OP did.

1- Intake rubber coupling too big for the throttlebody.

2- Couldn't screw the intake rubber mount properly. The whole is too small.

3- MAF sensor wire too short to connect.

4- Hose coming from the valve cover too short (2-3 inches) to connect to the intake.

5- The one at the bottom also is too short and doesn't look like it would fit anyway. So I guess I'm suppose to use the rubber cover. But what do I do with the 2nd hose then?

I'm confused. I mean, I installed entire turbo kits that where easier then that.

The instructions were useless because the pictures and instruction didn't fit my car at all.

I reinstalled the stock airbox and gave up after an hour of going nowhere.
QuickSiR is offline  
    Reply With Quote