Ford Focus Forum, Ford Focus ST Forum - View Single Post - 2005 ST 2.3 Rod Knock
View Single Post
Old 03-09-2013, 02:08 PM   #8
forddiesel1
Focus Jr. Enthusiast
 
Join Date: Nov 2012
Fan#: 106506
Location: Saint Paul, MN, MN
What I Drive: 2005 Silver ZX4 ST

Posts: 25
Points 93, Level 1
Points: 93, Level: 1 Points: 93, Level: 1 Points: 93, Level: 1
Level Up 86% Completed
Level up: 86% Level up: 86% Level up: 86%
Forum Activity 5%
Activity: 5% Activity: 5% Activity: 5%
FF Reputation: 1 forddiesel1 Good Standing Member
Buy-Sell-Trade Rating: (0)
Somewhere else I saw a torque figure for the 2.3 Ranger engine of 26ft-lbs followed by 90 degrees. I really don't intend on doing a full rebuild right now. I won't know for sure though until I tear into it. I'm thinking BSD since it looks like I'll have to pull the balance shaft anyway and it really can't be re-installed, plus a set of rod and main bearings and I'll be set to go again. If I see that the crank journals are scored up I'll have to explore other options, but I'm hoping for the best at this point.
forddiesel1 is offline  
    Reply With Quote