Focus Fanatics - View Single Post - 2005 ST 2.3 Rod Knock
View Single Post
Old 03-09-2013, 01:36 PM   #7
Egz
Sückn' n Blown
 
Egz's Avatar
 
Join Date: Sep 2003
Fan#: 442
Location: Tappahannock, VA
What I Drive: 2003 2.3l ZX3

Posts: 7,742
FF Reputation: 111 Egz Excellent Standing MemberEgz Excellent Standing Member
Buy-Sell-Trade Rating: (3)
All the bolts down there are torque-to-yield. Hayne's doesn't have the torque data, neither does Ford. Ford just replaces the entire engine instead of repairing.

That said, if you were planning on removing pistons, they have to come out the top, but the crank can stay in place if you choose. However, to get the head off, you need to remove the timing chain cover to get to the guides, since they bolt to the head and block. Its a real pain in the butt to R&R with the engine in the block. The easiest would be to do the conrod bearings, and use something like 60 ft-lbs + 90 degrees for a torque. I'm just guessing, I've always used aftermarket parts when rebuilding Duratecs.
__________________
January 2008 Focus Fanatics ROTM
2003 Ford Focus ZX3 2.3l N/A = 221 HP, 162 ft-lbs, 13.967@100.88MPH
2006 Ford Fusion 2.3l Turbo = 244HP, 247ft-lbs

duratec.wikispaces.com - Duratec Wiki - Sign up and contribute!
Egz is offline  
    Reply With Quote