Originally Posted by Pinion Dominion
Quick update on what's happening with the 3D Print. I'm almost finished designing the model.
I need to modify a few dimensions here and there but for the most part I am pretty happy with this design. I am also going to add a little bit the the rear of the tray (it'll be on top of the sd card and RCA in jacks but not the USB's) and make that into a dedicated change tray. I hope to have this completed tonight and a 3d print ready for next week.
The only problem I think there is - inside the console is an area designed to hold cd cases. If you put the cd cases in those designated slots, the top of the cases may hit the new little cubbies you added to the design.
Some of us still use cds! so this would be an issue in that case.
Mods: Drop in K&N filter, Steeda RSB, MS3 RMM, Remote start, Llumar tint, Ti engine cover, Husky floor mats, OEM splash guards