Focus Fanatics - View Single Post - SVT Focus Clutch
View Single Post
Old 02-09-2013, 08:06 PM   #1
Timken500
Focus Jr. Enthusiast
 
Join Date: Nov 2012
Fan#: 106781
Location: Houston, TX
What I Drive: 2004 Black SVT ZX3

Posts: 28
FF Reputation: 1 Timken500 Good Standing Member
Buy-Sell-Trade Rating: (0)
SVT Focus Clutch

Well finally was able to get the clutch installed. Went ahead and changed the Clutch with the Luk Full replacement kit that included the new bigger clutch and new Dual Mass flywheel and I love how it feels. While in their we replaced the Rear main seal as well with a new ford unit. Replaced all of the motor mounts the 2 top mounts were replaced with Ford pieces and the lower was down with the energy suspension bushings. Then we replaced the output shaft seals on the transmission and filled it up with new fluid from ford. Went ahead and replaced the 2 front struts with Bilstein factory replacements and the Strut mounts were also replaced with Moog Units. Finally replaced the Lower control arms with new Moog Units they came with new bushings and ball joints. Here are a few of the pictures of the old worn out old style clutch. Notice all the stress cracks in the pressure plate and how close I was to the rivets on the clutch disk.

Ok going to post pictures of the clutch need to get them hosted.


__________________
Drag Racing is a lot like sex whoever finishes first WINS !!!
Timken500 is offline  
    Reply With Quote