Ford Focus Forum, Ford Focus ST Forum - View Single Post - Help - Did I Mess Up a Head Install?
View Single Post
Old 02-09-2013, 03:09 PM   #1
sdaddy
Focus Jr. Enthusiast
 
sdaddy's Avatar
 
Join Date: Oct 2012
Fan#: 105173
Location: El Sobrante, CA
What I Drive: Green 2002 Birkin w/2L Zetec

Posts: 36
FF Reputation: 1 sdaddy Good Standing Member
Buy-Sell-Trade Rating: (0)
Help - Did I Mess Up a Head Install?

After carefully cleaning the block surface, etc., I have just finished torqueing the new head bolts and.... panic!

Little tabs are sticking out at the front and rear of the exhaust side. They have small brass grommets.


Looking at the old gasket, I can see the same tabs but I can't recall if they stuck out.




The tab with the three bumps is exhaust side and front of the motor. Did I install the gasket the wrong way??


sdaddy is offline  
    Reply With Quote