Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Stance for the MK3
View Single Post
Old 02-03-2013, 01:03 AM   #3
Errant Erik
Focus Rookie
Join Date: Oct 2008
Fan#: 60085
Location: VoCo Florida
What I Drive: '01 Black ZX3

Posts: 12
FF Reputation: 1 Errant Erik Good Standing Member
Buy-Sell-Trade Rating: (0)
Originally Posted by Chaos09 View Post
My 9" wide wheels are et36. The rear sits flush due to the -2 degree camber. The front sticks past about 3-4mm. I'm going to pull my front fenders. I can barely get a finger between the wheel and the coilovers. Hope this helps.
It does, but now is that finger between the wheel and coilover in the front or back, or both? Also how thick are your fingers? lol

I think once i get the coils on i'll do some wood work and make a circle of plywood that is 18" in diameter, drill holes to match our pcd and hub bore and throw it on, so i can pull more concrete measurements from it...

And did you reveal your wheels yet, last I saw it was just a teaser pic of the wheel in that truck bed
Errant Erik is offline  
    Reply With Quote