Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Aluminum Flywheel Question
View Single Post
Old 02-01-2013, 05:25 PM   #7
svtguy88
Focus Fanatic
 
svtguy88's Avatar
 
Join Date: Sep 2004
Fan#: 13476
Location: Menomonee Falls, WI
What I Drive: 2003 Infra Red SVT

Posts: 2,984
Points 8,577, Level 62
Points: 8,577, Level: 62 Points: 8,577, Level: 62 Points: 8,577, Level: 62
Level Up 43% Completed
Level up: 43% Level up: 43% Level up: 43%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 17 svtguy88 Great Standing Member
Buy-Sell-Trade Rating: (2)
Don't know the specifics on the Spec clutch -- it wasn't the "go to" when I bought my clutch/flywheel.

That being said -- there are two stock designs for the clutch and flywheel, pre- and post-TSB.

To make a long story short(er), if you have the old (pre-TSB) clutch and flywheel, you'll be replacing both, as the design got revamped. If you've already got the post-TSB setup, then your options are a bit more open (you could, in theory, replace just the clutch, or just the flywheel with some other ones -- I believe). However, as mentioned above, if you are going deep enough to change the clutch, you may as well just do the flywheel at the same time.

FWIW, I've got the Clutchmasters stage 1 with the light flywheel, and love it. Just enough of an increase in pedal pressure, without it being obnoxious -- and the lighter flywheel helps out a *lot* with the hanging RPM's that the SVT is so famous for...
svtguy88 is offline  
    Reply With Quote