Ford Focus Forum, Ford Focus ST Forum - View Single Post - Need help with finishing a bare metal surface
View Single Post
Old 01-27-2013, 07:47 PM   #4
UnbridledCarnage
Rhinoliner!!!
 
UnbridledCarnage's Avatar
 
Join Date: Jul 2009
Fan#: 66551
Location: Louisville, KY
What I Drive: 03 Rhinoliner'd ZX3 AdvanceTrac

Posts: 2,573
Points 16,186, Level 81
Points: 16,186, Level: 81 Points: 16,186, Level: 81 Points: 16,186, Level: 81
Level Up 68% Completed
Level up: 68% Level up: 68% Level up: 68%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 9 UnbridledCarnage Good Standing Member
Buy-Sell-Trade Rating: (5)
what he said on polishing the tank karyn. i polished the lip on my 10 holes with that method. just MAKE SURE YOU WET SAND. and keep it wet. you'll notice the water turning white and that means your doing it right. alot of elbow grease. i jacked the front of the car up and had someone tap on the gas instead of working my way around the wheel. Good luck!
__________________
If your local to the 502, 270, 812, 606, 859 area, check out FocusXtreme, the Ohio Valley chapter of FF. Monthly meets and kickass people! Join and POST UP!!!
UnbridledCarnage is offline  
    Reply With Quote