Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Steering pinion gear removal
View Single Post
Old 01-27-2013, 03:22 PM   #1
petik
Focus Enthusiast
 
Join Date: Sep 2003
Fan#: 461
Location: Austin, TX
What I Drive: 2002 Pitch Black ZX3

Posts: 179
Points 1,447, Level 21
Points: 1,447, Level: 21 Points: 1,447, Level: 21 Points: 1,447, Level: 21
Level Up 47% Completed
Level up: 47% Level up: 47% Level up: 47%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 1 petik Good Standing Member
Buy-Sell-Trade Rating: (8)
Question Steering pinion gear removal

A bit of background:

I'm building a kit car (MEV Rocket) that is based on the 2.0L zetec focus setup. Much of the powertrain and drivetrain is transplanted including steering.

One of the problems is that in the kit car, power steering is eliminated. This results a an whopping 4.5 turns lock to lock. Clearly not a track-friendly steering ratio. Good news is that quaife makes a quick-steering rack and pinion replacement, but you only get just the rack and the pinion gear.

Issue:

I got the inner tie rods out of the rack and disconnected the steering arm from the pinion, but I can't figure out how to get the pinion gear bear out. The photo shows the gear and the bearing on top of it, but i don't see a retaining clip to pull out. Do i need a special tool to pull the bearing out? Is it threaded? Any help/advice would be much appreciated.




__________________
MEV Rocket - zetec with powerworks sc
04 BMW M3 Convertible - bone stock
'02 ZX3 - returning to stock
'99 F350 PWS 4x4 Dually - chipped, 4" exhaust, intake, stg1 injectors
petik is offline  
    Reply With Quote