Ford Focus Forum, Ford Focus ST Forum - View Single Post - Utahns
Thread: Utahns
View Single Post
Old 01-26-2013, 10:14 AM   #9328
Magus2727
Focus Fanatic
 
Magus2727's Avatar
 
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 4,257
Points 7,986, Level 60
Points: 7,986, Level: 60 Points: 7,986, Level: 60 Points: 7,986, Level: 60
Level Up 18% Completed
Level up: 18% Level up: 18% Level up: 18%
Forum Activity 34%
Activity: 34% Activity: 34% Activity: 34%
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
No, as usually I could not leave stuff enough alone. I had it welded with a MIG with Argon. But dome of the areas were a little difficult and the weld was not that good looking of a weld. I have a oxygen acetylene torch at home and it was recommended to me to reflow some of the welds. Apparently I way overheated the pan vs the bung and had fracture cracks in the pan. I tried fixing those but must have been to hot again because they just got bigger and now I have gaping holes. the only way to fix it now is JB weld and I want to do this right....
__________________
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (http://www.focusfanatics.com/forum/showthread.php?t=289168&referrerid=62897)
Magus2727 is offline  
    Reply With Quote