Focus Fanatics - View Single Post - quick question
Thread: quick question
View Single Post
Old 01-22-2013, 01:18 AM   #11
Duhamel
Focus Enthusiast
 
Duhamel's Avatar
 
Join Date: Sep 2010
Fan#: 78883
Location: Edmonton, Canada
What I Drive: 2009 Silver SES

Posts: 265
FF Reputation: 1 Duhamel Good Standing Member
Buy-Sell-Trade Rating: (0)
Baldurs,

Did you remove the grille from the full piece with the honeycomb/mesh part? As in, you only had the part with the two bars and logo to tend with? Just asking. All I used was cheap grey primer, 3 coats, and Dupli-color black, 3 coats, and put each coat on while the other was slightly tacky (5-10 minutes), which was after sanding the entire surface with 360 grit and wiping it with a tack/tacky cloth. The only issue is re-attaching the grille. I had to use 3m double-sided "tape". You can easily see the bolt that holds the logo on when you have it separated from the honeycomb/mesh part.

Mine's held up for over 8,000 miles/12,000 kms with barely any chipping, and it was chrome to begin with.

Edit - I also prepped and painted my fog bezels and chrome accent rings with the same process and color, which is holding up even better than the grille. I can't stand the flat black plastic crap.
Duhamel is offline  
    Reply With Quote