Focus Fanatics - View Single Post - finally starting my journey to 450whp
View Single Post
Old 01-21-2013, 11:26 AM   #72
1turbofocus
FF Affiliate
 
1turbofocus's Avatar
 
Join Date: Oct 2003
Fan#: 1123
Location: Belmont, NC
What I Drive: 2000 ZX3 / 2002 SVT Turbocharged

Posts: 21,674
FF Reputation: 153 1turbofocus Excellent Standing Member1turbofocus Excellent Standing Member
Buy-Sell-Trade Rating: (28)
No thats even if they build one of there own , if you build the engine right and do the proper machine work thats needed you will have 2800 to 3000 in a Zetec engine

square block / surface by squaring the block I mean install a special bar into that mains saddle and measure from that bar to the deck on both ends of the block and surface till the block is the same , I have never had a block that wasnt at least .0015 out to as much as .011 out
surface head
balance rotating assy
do oil holes in block and massage oil pump
tq rod bolts with stretch gauge
change stock oil plugs to NPT plugs
set rod and main bearing clearances (not plasti-gauge)
line bore after going to ARP main studs
and on and on , people dont have the tools to do these things with a build it your self so a machine shop should be doing this and that cost money

Now if your just talking throwing a set of rods and pistons in , plastigauge it , head and main studs etc and let it go sure you can save money but why not do it right for just a little more money

Tom
__________________
Focus-Power: Your #1 Source for Ford Focus Speed, Tuning & Performance!

Customer Support
AIM: hpdyno
Email: hpdyno@aol.com
Phone: 704-249-3745
Site: focus-power.com

Elder 1turbofocus
1turbofocus is offline  
    Reply With Quote