Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Oxygen Sensors, OL faults, and crazy volts
View Single Post
Old 01-21-2013, 12:47 AM   #13
amc49
Focus Fanatic
 
Join Date: Mar 2012
Fan#: 96610
Location: Fort Worth, TX
What I Drive: 00 wagon, 02 sedan both zetec atx

Posts: 5,513
Points 3,183, Level 34
Points: 3,183, Level: 34 Points: 3,183, Level: 34 Points: 3,183, Level: 34
Level Up 89% Completed
Level up: 89% Level up: 89% Level up: 89%
Forum Activity 50%
Activity: 50% Activity: 50% Activity: 50%
FF Reputation: 25 amc49 Great Standing Member
Buy-Sell-Trade Rating: (0)
Sure you don't have vacuum leak? Will start up fine cold and warm up until going to CL then when O2 doesn't switch the system shows fault. Motor goes to crap at that point. Upstream will show like .1 volt and no switching, stuck on low volts.........I've have them run for a good while (week plus) and never post a light doing that. Will run fine at higher than idle speeds since the leak affects less there.

On both of mine the PCV entry point at manifold was cracked open.

My cars read 18-19% TPS at idle running normally.
amc49 is offline  
    Reply With Quote