Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - there a way I can take my t/b apart even if it's fbw
View Single Post
Old 01-18-2013, 04:59 PM   #2
Snigle
Focus Rookie
 
Join Date: Jun 2009
Fan#: 65662
Location: Milwaukee, WI, WI
What I Drive: 2007 Silver SE

Posts: 10
FF Reputation: 1 Snigle Good Standing Member
Buy-Sell-Trade Rating: (0)
I just cleaned mine the other week. It was actually super easy and fixed my sticking accelerator peddle.

1) Disconnect intake hose between air resonator and throttle body. This can be done by loosening the two clams with a flat head screwdriver. It will take some wiggling but it will pop off of the resenator and throttle body.
2) Disconnect sensor cable from throttle body
3) Disconnect the accelerator cable & cruse cable from throttle body
4) Unscrew plastic cover near throttle body
5) Unscrew the 4 bolts that connect the throttle body to the engine.

It should pull right off. On my focus it was made of plastic, so be careful what type of clearer you use. I used this: http://www.amazon.com/CRC-05078-Thro...dp/B000M8PYO2/

My focus is an 07, but I'm sure the 10 is similar.
Snigle is offline  
    Reply With Quote