Quote:
Originally Posted by JL330
I royally messed up the last set of headlights I put in the oven. One of the lenses melted a little and both of them ended up looking etched really bad. That oven may have run hotter than it should though.
|
It should only be on warm which is maybe 250 degrees.
Quote:
Originally Posted by e30og
Someone correct me if Im wrong, but condensation just means either a crack somewhere or some part of the edges glued together isnt 100% sealed, right? As long as you really get the pieces glued together well, there should be no issue?
Also Chickenmuffin did this with a heat gun, which wont heat the entire lens. Here is his writeup:
http://www.focusfanatics.com/forum/s...eadlight+bezel |
Ya it just means it's not perfectly sealed. Do not use a heat gun, you risk cracking the lens when pulling it apart due to the uneven heat distribution.