Ford Focus Forum, Ford Focus ST Forum - View Single Post - WTB: AEM intake - throttle body elbow - zetec
View Single Post
Old 01-16-2013, 01:49 PM   #1
Mile30
Focus Fanatic
 
Mile30's Avatar
 
Join Date: Apr 2010
Fan#: 74686
Location: Westminster, MD
What I Drive: '03 ZX3

Posts: 1,842
Points 7,787, Level 59
Points: 7,787, Level: 59 Points: 7,787, Level: 59 Points: 7,787, Level: 59
Level Up 19% Completed
Level up: 19% Level up: 19% Level up: 19%
Forum Activity 1%
Activity: 1% Activity: 1% Activity: 1%
FF Reputation: 7 Mile30 Good Standing Member
Buy-Sell-Trade Rating: (10)
WTB: AEM intake - throttle body elbow - zetec

I disassembled my cold-air intake to group it with a pile of parts due for the powdercoaters on Monday; but the rubber boot/elbow that connects the MAF section of the intake to the throttle body had become fused with the tube...

I asked the metal refinisher people to just cleanly slice the boot and remove it if worst-came-to-worse, so not to damage the tubing; he ended up bending the hell out of the end of the tube using a screwdriver AND ripped some of the rubber from the inside of the boot as he tore it off. Sooooo; now I can't even use the elbow again AND the tube was compromised!!! The chewed-end is facing the camera; YOU SEE IT?!?!


I need a new/used-but-safe rubber elbow for the throttle body-to-tube portion! And possibly a new upper intake tube (depending on how the finished job turns out!)!

Here's the part I need:




Can anyone oblige?!


__________________
"I'm gonna sing the doom song..."
Mile30 is offline