Ford Focus Forum, Ford Focus ST Forum - View Single Post - Special Tool Required for Brake Master Cylinder Replacement?
View Single Post
Old 01-16-2013, 07:34 AM   #5
bennyfocus
Focus Enthusiast
 
bennyfocus's Avatar
 
Join Date: Sep 2007
Fan#: 50465
Location: Lock Haven, PA
What I Drive: 2001 Blue Zx3

Posts: 156
Points 1,188, Level 18
Points: 1,188, Level: 18 Points: 1,188, Level: 18 Points: 1,188, Level: 18
Level Up 88% Completed
Level up: 88% Level up: 88% Level up: 88%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 6 bennyfocus Good Standing Member
Buy-Sell-Trade Rating: (2)
No sleepyboy is right, on some occasions you may need a scan tool capable of bleeding the abs out. Personally I have only ran into that issue once or twice. Also something else I think they listed as "special equipment" is a pressure bleeder, I think they prefer you pressurize the master then crack open the bleeders. As long as you bench bleed the master before you put it on then bleed the system like you normally would on any other car you should be fine.
bennyfocus is offline  
    Reply With Quote