Ford Focus Forum, Ford Focus ST Forum - View Single Post - FSWerks Cool-Flo Intake Installation Problems
View Single Post
Old 01-09-2013, 08:17 PM   #84
TMDJ5
Focus Enthusiast
 
Join Date: Dec 2012
Fan#: 107386
Location: Drexel Hill, PA
What I Drive: 2011 Black Ford Focus SE 2.0

Posts: 64
FF Reputation: 1 TMDJ5 Good Standing Member
Buy-Sell-Trade Rating: (0)
That hose that hooks up under the bottom of the intake, do you remember if that's should be pushed all the way through the rubber fitting? Or should it seat right in the middle of it?

And the other hose that connects to the valve cover I don't trust either. I forced it in as deep as it can go but it's not secured by anything. It's just sort of wedged. I know it's not the silicone end links. Those are even and the clamps are tight and when I have my dad rev the engine that hissing noise is coming from one of the two pipes. I'll try fiddling around with tomorrow after work.
TMDJ5 is offline  
    Reply With Quote