Ford Focus Forum, Ford Focus ST Forum - View Single Post - Rebuilding Duratec 20?
View Single Post
Old 01-07-2013, 03:55 PM   #1
bobpage
Focus Rookie
 
Join Date: Jan 2013
Fan#: 108003
Location: Seattle, WA
What I Drive: 2005 Ford Focus ZX3

Posts: 1
FF Reputation: 1 bobpage Good Standing Member
Buy-Sell-Trade Rating: (0)
Rebuilding Duratec 20?

Hey everybody,

I'm new to Focuses and just recently had to work on a 2005 Ford Focus (unrelated to engine) and so I went out and bought a Chilton manual. While flipping through it I noticed that in the engine section it says something along the lines of "due to the tight clearances of the 2005 and on engines, the engine must be replaced as a unit and is not serviceable". I also lists NA for all the torque specs and states that Ford does not sell the parts to rebuild the engine.

To be honest I was kind of shocked, as I had always assumed that you can just rebuild an engine if you choose to do so. Has anyone attempted to rebuild one of these "unserviceable" engines? If so, how did it go? I'm assuming you have to get all the parts aftermarket, but then how do you get all the specs needed to put it together?


bobpage is offline  
    Reply With Quote