Focus Fanatics - View Single Post - Power Steering Pump high pressure fitting
View Single Post
Old 12-29-2012, 11:19 PM   #1
Joelnaf
Focus Jr. Enthusiast
 
Joelnaf's Avatar
 
Join Date: Dec 2011
Fan#: 93167
Location: Fairfield, CA
What I Drive: 2003 Silver ZX5 SVT

Posts: 35
FF Reputation: 1 Joelnaf Good Standing Member
Buy-Sell-Trade Rating: (0)
Power Steering Pump high pressure fitting

Hey everyone, so i've just had my motor out of my car because I was doing a ton of work and decided it would be easier outside the car..... anyways I installed the motor and it runs great but I developed a really bad power steering leak. I did not disconnect the power steering fitting (i took the pump off the motor and swung it out of the way to get the motor out). Now that i reinstalled it and the hose in the fitting is loose. The fitting is as tight as I can get it but the hose has wiggle room and letting fluid by. Obviously the hose is not seating on the inside of the pump and as a result it is leaking very badly.

Bottom line: Power steering high pressure fitting is tight but the hose is not seating causing it to leak.

I was doing research on it and some guys in England say that it needs a modified hose and pump???? I just don't want to have to replace the whole power steering hose.

Has anyone else experienced this problem or do I just need a new hose?
Thanks everyone!!


Joelnaf is offline  
    Reply With Quote