Focus Fanatics - View Single Post - Header and exhaust install questions
View Single Post
Old 12-28-2012, 04:43 PM   #1
nowhere67
Focus Jr. Enthusiast
 
Join Date: Dec 2011
Fan#: 92834
Location: Sicily, Italy
What I Drive: 2010 Sterling Grey Automatic SE

Posts: 34
FF Reputation: 1 nowhere67 Good Standing Member
Buy-Sell-Trade Rating: (1)
Header and exhaust install questions

So i finally got around to getting the bung welding onto my flexpipe for my wideband. I started going over all of my parts to install the fswerks header and stealth exhaust but noticed i am missing the gasket that goes between the header and the flexpipe. So I know i can reuse the original manifold gasket, but as long as i don't destroy it, can i reuse the flange gasket? If anything just for temporary use until i can get a hold of a replacement. Also, i do not have a tune yet and it may be a while before i can get one. Is it ok if i drive with the new header without a tune and just ignore the CEL? I am installing the wideband so i can monitor my AFR to see if i go too lean.


__________________
CFM CAI w/ bypass valve
FSWERKS Stealth Exhaust
A103 Spark Plugs .055 Gap
nowhere67 is offline  
    Reply With Quote