Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Zetec rebuild questions
View Single Post
Old 12-22-2012, 10:06 PM   #20
sleepyboy
FF's Night Security
 
sleepyboy's Avatar
 
Join Date: Nov 2004
Fan#: 15335
Location: SW Houston, TX, United States
What I Drive: 01' Yellow ZX3 euro, 04' ZX5 SVT

Posts: 26,349
Points 135,964, Level 100
Points: 135,964, Level: 100 Points: 135,964, Level: 100 Points: 135,964, Level: 100
Level Up 0% Completed
Level up: 0% Level up: 0% Level up: 0%
Forum Activity 65%
Activity: 65% Activity: 65% Activity: 65%
FF Reputation: 48 sleepyboy Great Standing Member
Buy-Sell-Trade Rating: (11)
I do feel porting doesn't hurt, but mainly the pump in power from head work is from the compression bump, more squish equals bigger bangs.

For my car right now all I have left do is head work. I know I'll get a substantial increase in power from it as well. A full bolt on car can only pull roughly 140whp where as one with a P&P head can pull up to 160-170 whp. Most of the gain is from the head work. Though if you looking for any serious power you need boost, there is no way around that. I don't know where all this no porting the head came talk came from unless we're talking boost? If going n/a it's really not cost effective to go that route cause in the end you would have spent just as much if not more than you would have for boost and end up with 100 less hp and way less tq.
__________________
I started out with nothing and I still have most of it left

Hatch Nation #15 (Ole' Yeller') & #150 (The SVT)
Moderator for
Technical Chat
Zetec Performance Chat
Southern Fanatics Chat
sleepyboy is offline  
    Reply With Quote