Focus Fanatics - View Single Post - 2010 focus door problems
View Single Post
Old 12-19-2012, 12:55 PM   #2
gtferrari
Focus Addict
 
gtferrari's Avatar
 
Join Date: Jul 2011
Fan#: 88110
Location: Grand Rapids/Big Rapids/Bangor/South Haven, MI
What I Drive: 2008 Vista Blue SES Coupe

Posts: 575
FF Reputation: 4 gtferrari Good Standing Member
Buy-Sell-Trade Rating: (0)
i would get a wiring diagram and a dvom (digital volt ohm meter)
use the diagram to figure out what wires to test for. look for the ground wire. in ohm mode connect one lead to the ground and the other to the neg terminal on the bat. should read 0.0

now set it to vol= not vol~ find the positive wire and put a lead on that then leave the other on the neg term of the batt. press the button. you should see 12.6 volts

most likely you are looking for a bad ground or resistance in the wires or connections
__________________
2008 Vista Blue SES Coupe 5spd FRPP Zx3B Suspension
5000K D2S Retrofit
130,000+ miles and still on factory brakes and clutch!

Rep Points dont add themselves
gtferrari is offline  
    Reply With Quote