Ford Focus Forum, Ford Focus ST Forum - View Single Post - LCQ-1 install
Thread: LCQ-1 install
View Single Post
Old 12-14-2012, 03:48 PM   #1
Besbro
Focus Enthusiast
 
Besbro's Avatar
 
Join Date: Aug 2012
Fan#: 102785
Location: Garson, Canada
What I Drive: 2012, black SE Sport

Posts: 62
FF Reputation: 1 Besbro Good Standing Member
Buy-Sell-Trade Rating: (0)
LCQ-1 install

Hello, I will be replacing my LOC for a LCQ-1 in a couple days. I am running a front stage and one 10 inch sub off separate amps. I had the stock 6 speaker system initially. Would I be better to run the front speaker wires into channel 1 and the rear speaker wires into channel 2 (for the sub) on the LCQ-1 or is it better just to run the front speaker wires into channel 2 and leave the rear speaker wires disconnected? I know the LCQ-1 gets its sub signal off the channel 2 signal. I read that the rear speaker signal is not complete, that anything lower than 45 hz is cut off, but the front signal is complete. Is this true?

Thanks!


Besbro is offline  
    Reply With Quote