lol , too late geezer i already did it.
but thanks for the info . and mike , this stuff was hardining before i even started putting it on , it filled the rash very well... the last time i used regular jb it was much more watery than this . i was actually worried about just that lol. i think the quik weld " mistake " buy was actually a good thing :D
i will sand it tomorrow , maybe 60 grit will rough it out good ...?.?...and then a higher grit for smoothing.?..?
btw , its only been on for less than an hour and is ROCKED. i like this stuff
Sent from my N860 using FF Mobile