Focus Fanatics - View Single Post - increase rear sway stiffness
View Single Post
Old 12-04-2012, 12:26 PM   #1
c03morrison
Focus Addict
 
c03morrison's Avatar
 
Join Date: May 2007
Fan#: 47010
Location: massachusetts, United States
What I Drive: 04 tundra zx3

Posts: 740
FF Reputation: 6 c03morrison Good Standing Member
Buy-Sell-Trade Rating: (4)
increase rear sway stiffness

so ive been browsing and trying to figure out ways to make the stock sway a little stiffer without upgrading to a bigger size. ive seen kids drill added holes on the inside of the stock holes where the endlinks mount. for the rear i noticed you cant do this cus there isnt enough space in the flat stock section. another idea was increasing or decreasing the size of the endlinks but not sure if that will do much. what do you guys and gals think.

By putting a bigger or smaller endlink bolt which will make for a softer or harder feel on the sway.

my goal is to eventually get a bigger bar but i want to hold off till a warmer month cus i will want to add metal to the control arms so they wont break on me.


__________________
04 light tundra green metalic zx3, cia w/ K&N filter, fc 4-2-1, 2.5 bolra trubendz, eibach sportline kit, tinted tails and side blinkers, euro headlights, sct chip, oem cf hood, euro replica bumper
c03morrison is offline  
    Reply With Quote