Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Bung size for an EGR weld-on a SVT header?
View Single Post
Old 12-03-2012, 06:21 PM   #10
pkolator
Focus Enthusiast
 
pkolator's Avatar
 
Join Date: Mar 2010
Fan#: 73320
Location: Cary, IL
What I Drive: 2002 Infra-Red ZX3

Posts: 122
Points 1,070, Level 17
Points: 1,070, Level: 17 Points: 1,070, Level: 17 Points: 1,070, Level: 17
Level Up 70% Completed
Level up: 70% Level up: 70% Level up: 70%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 2 pkolator Good Standing Member
Buy-Sell-Trade Rating: (3)
This place...

http://www.adaptall.com/products/carbonsteel/9236.html

...seems to have a lot of adapters. 9236-22-22 would be the correct size then to connect the tube to bung? I'm going to put a call into these guys tomorrow.
__________________
Tri-State Sports Car Council/Chicago Region SCCA/Milwaukee Region SCCA
Do better every run.
2002 ZX3 (daily)
1990 CRX Si STS (autox)
pkolator is offline  
    Reply With Quote