Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Trip computer not displaying MPG, read 0!
View Single Post
Old 12-01-2012, 03:29 PM   #1
jellymonster
Focus Rookie
 
Join Date: Nov 2012
Fan#: 106334
Location: Southampton, United Kingdom
What I Drive: 2003, Magnum Grey, Focus

Posts: 8
FF Reputation: 1 jellymonster Good Standing Member
Buy-Sell-Trade Rating: (0)
Exclamation Trip computer not displaying MPG, read 0!

Hi,

I have retrofit the trip computer into my 2003 Zetec focus. I didn't have the wiring loom there, so I had to wire it myself using this guide:
http://www.luckyb.pwp.blueyonder.co....too%20comp.pdf

I can see l/h, but when I change it to mpg, it read 0. There are some other ones that don't work as well, but I think they are caused by the same thing.

There are 4 wires I haven't wired in yet. 2 for temperature, 1 for washer fluid and the wire that goes to the Central Timer module (airbag diagnostic connector under centre console, pin 16). I was under the impression that this wire was for a beeping sound? So I wasn't too fussed about that,

Also, the backlight brightness doesn't adjust with the instrument cluster, clock etc. It just stays the same.

Does anyone know what wire may be causing this? Or have any suggestions?


jellymonster is offline  
    Reply With Quote