Focus Fanatics - View Single Post - Incognito27`s 2003 ZX5 Build
View Single Post
Old 11-28-2012, 06:15 PM   #20
Incognito27
Focus Addict
 
Incognito27's Avatar
 
Join Date: May 2006
Fan#: 34939
Location: Ottawa, Canada
What I Drive: 2003 Ford Focus ZX5 Premium - White

Posts: 625
FF Reputation: 3 Incognito27 Good Standing Member
Buy-Sell-Trade Rating: (1)
So another update , bumper is repaired fully , and the following are pics of my repair.



This was the worst repair on the thing , as it was a pressure joint , so it deserved a little more attention. so in the back looks ugly, but the front looks good.



this was a simple matter of reinforcing the crack which is not a supporting crack , but it is repaired and reinforced.



Some more of the reinforcement and repair



some more reinforcement




the front facing side of the first image , the major repair crack.



This is after today , 1st coat of white finally went on , after a few bouts of primer and wet sand to smooth it.





Tomorrow a little wet sand for a little over spray , then another coat of white . and wetsand , then clear coat.

keep in mind i am also doing this when it is far too cold to be doing this. i am baking the bumper useing a heat gun ...... not the best way to do this. but since i am in a competition with father time , and mother nature .

i want this on for the winter.

So thats where i am at. when i have the clear coat on and the lip and grill oni will take a few more pictures to show.
Incognito27 is offline  
    Reply With Quote