Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Replace master cylinder clutch
View Single Post
Old 11-25-2012, 02:44 PM   #113
LugNut
Focus Enthusiast
 
LugNut's Avatar
 
Join Date: Nov 2011
Fan#: 92146
Location: N.E., KS
What I Drive: 2001 White Sedan

Posts: 160
Points 1,664, Level 23
Points: 1,664, Level: 23 Points: 1,664, Level: 23 Points: 1,664, Level: 23
Level Up 64% Completed
Level up: 64% Level up: 64% Level up: 64%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 1 LugNut Good Standing Member
Buy-Sell-Trade Rating: (1)
I just replaced the clutch master cylinder yesterday in the 2001 SE -- the OP's pics and descriptions helped as did the FSM.

I didn't need to remove the seat, nor the clutch pedal or the two or three colored switches. Did remove the clutch safety switch, and then carefully bent its bracket 45 degrees down to allow the master cylinder to come out and the new one to go in. The upper (of two) mounting bolt for the master cylinder was the biggest pain of the job.

After gravity-flushing the brake fluid, I used the fish-tank tube from the bleed-port to the fluid reservior technique for bleeding. Took 100 or more pumps to clear the fluid.

The replacement clutch master cylinder, $35 from AutoZone (PN 51370), was a LuK that was identical to the original 2001 LuK part that was removed.
__________________
---
LugNut

Fixed Up a white 2001 P-code SE Sedan
including rebuilding the SPI (see my threads)
LugNut is offline  
    Reply With Quote