Quote:
Originally Posted by pyroinsa
Any auto parts store carries it, look for the paint code on your door, it should be a 2 letter code and just match it up to the rattle cans. Yes I sanded after I applied plastic primer going from a 400 all the way to 1000 grit. Sand between coats and keep stepping up the sandpaper to a finer grit each time. Clear it in the same manner, but use1500 grit between coats of clear, followed by a rubbing compound and wax a week later
Sent from my iPhone using FF Mobile
|
so no sanding before prime? then prime,sand from 4 to 1000 and then paint , clear , sand with 1500 , then reclear????? sorry about all the questions , just wanna make sure iv got these instructions correct so i can do this right the first time.
