Focus Fanatics - View Single Post - Offset 10+
Thread: Offset 10+
View Single Post
Old 11-14-2012, 11:39 PM   #14
darkstar
Focus Enthusiast
 
darkstar's Avatar
 
Join Date: Jun 2005
Fan#: 23957
Location: North Houston, TX
What I Drive: 2002 liquid grey zx3

Posts: 84
FF Reputation: 1 darkstar Good Standing Member
Buy-Sell-Trade Rating: (2)
Factory springs shouldn't be cut yes but progressive springs which I have already can be cut, lot of people have done it even on coilovers.
I am not talking about suspension travel, the damper travel itself. Lets say that the valving in the chamber is sitting in the middle at normal height. Suppose you cut the rod 1 inch shorter then the valve will sit 1 inch higher at same height. Therefore if I cut the springs and rod 1 inch the valving will be at "middle"
darkstar is offline