Ford Focus Forum, Ford Focus ST Forum - View Single Post - 2012 Focus, how/where to pass wires through firewall?
View Single Post
Old 11-14-2012, 10:16 PM   #2
FocusBastard
Focus Enthusiast
 
Join Date: Aug 2012
Fan#: 103053
Location: Montreal, Canada
What I Drive: 2012 Black Focus SE Hatch, 5spd

Posts: 52
FF Reputation: 2 FocusBastard Good Standing Member
Buy-Sell-Trade Rating: (0)
Hey thanks for all the help guys!

Found what I was looking for.

Howto:

Remove glove box
- remove fuse panel cover under glove box (pull off the retainers)
- Open glove box, remove torx screws in the front on the top panel
- crawl under glove box, remove two more torx screws
- All torx screws are black oxide, hard to spot but look for em

upper right of fuse panel.... slits in jute padding
Rip the jute padding open to expose...
wiring harness coming in through a guge rubber grommet

take sharp tip knife and stab the rubber grommet like this \
remove knife and stab same point, like that /
makes a nice X

poke wire through x

Done.

Hopefully this helps some 2012 owners.
FocusBastard is offline  
    Reply With Quote