Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Wire/Part identification
View Single Post
Old 11-09-2012, 08:32 AM   #1
RugbyMadNut
Focus Rookie
 
Join Date: Oct 2012
Fan#: 104477
Location: London, United Kingdom
What I Drive: 2002 Silver Saloon

Posts: 8
FF Reputation: 1 RugbyMadNut Good Standing Member
Buy-Sell-Trade Rating: (0)
Wire/Part identification

Hi All,

I'm going to replace my spark plugs, HT leads and ignition coil at the weekend. This is because I've been getting juddering and misfires at low revs in the lower gears.

I was checking last night that I had the right Torx screwdriver for the ignition coil when I noticed a wire coming from the cylinder head between plugs 2 and 3.

Any idea what this is or what it is connected to? A sensor perhaps?
It's a bit dirty, wet and grotty in the channel the plugs sit in on the cylinder head... this can't be good right? I'll give it a good clean before I remove the plugs first!

Any answer on the unknown wire would be great!

car details = 2002, 1.6 Ghia saloon.


RugbyMadNut is offline  
    Reply With Quote