Ford Focus Forum, Ford Focus ST Forum - View Single Post - Idle vibration
Thread: Idle vibration
View Single Post
Old 10-05-2012, 08:21 PM   #5
suss6052
Focus Addict
 
suss6052's Avatar
 
Join Date: Feb 2012
Fan#: 95752
Location: ..., MI
What I Drive: 2013 Ford Focus ST2 Ingot Silver

Posts: 12,439
Points 9,430, Level 65
Points: 9,430, Level: 65 Points: 9,430, Level: 65 Points: 9,430, Level: 65
Level Up 27% Completed
Level up: 27% Level up: 27% Level up: 27%
Forum Activity 27%
Activity: 27% Activity: 27% Activity: 27%
FF Reputation: 23 suss6052 Great Standing Member
Buy-Sell-Trade Rating: (3)
Quote:
Originally Posted by Michaelc1220 View Post
Ive seen people saying not to replace the motor mounts and to clean some part under the motor but im not exactly sure where.. and the motor mounts should not need to be replaced after 2 months, that would be an incredibly short live span IMO
It wouldn't be that the mount was bad that some of the people want to change at least one of them, but that's the rear motor mount (RMM) or power train roll restrictor. That one allows the engine to tilt under load and absorb some of the slack in the power train, but too much slack leads to a disconnected driving experience. The stock mount is mostly made of rubber there where as the Mazda MazdaSpeed 3 rear mount is much more solid. Although that might nominally increase engine vibration felt in the cabin, it can help tighten up the roll of the power train allowing for less power to be wasted in this fashion. But its not likely to show up on a dynomometer.
suss6052 is online now  
    Reply With Quote