Ford Focus Forum, Ford Focus ST Forum - View Single Post - Engine Mounts - Aftermarket any good? (i.e. westar, etc...)
View Single Post
Old 10-05-2012, 05:31 PM   #34
amc49
Focus Fanatic
 
Join Date: Mar 2012
Fan#: 96610
Location: Fort Worth, TX
What I Drive: 00 wagon, 02 sedan both zetec atx

Posts: 4,877
Points 2,838, Level 32
Points: 2,838, Level: 32 Points: 2,838, Level: 32 Points: 2,838, Level: 32
Level Up 59% Completed
Level up: 59% Level up: 59% Level up: 59%
Forum Activity 81%
Activity: 81% Activity: 81% Activity: 81%
FF Reputation: 23 amc49 Great Standing Member
Buy-Sell-Trade Rating: (0)
I'm learning to rebuild my pass side mounts. Got old Anchors running now without the hydraulic part in them at all. They are as smooth as Ford mounts now. The bottom rubber was still in excellent shape, just the tops blew out of them. I replaced all the junk in there with a big rubber donut after rigging a stud up through the middle to hold it. Cost $20 a piece. Got 3 up and running now, they certainly work better than stock Anchor did.
amc49 is offline  
    Reply With Quote