Ford Focus Forum, Ford Focus ST Forum - View Single Post - Bang/Knock/Clunk sound when releasing clutch
View Single Post
Old 09-24-2012, 11:15 AM   #4
flaurencelle
Focus Jr. Enthusiast
 
flaurencelle's Avatar
 
Join Date: May 2006
Fan#: 35294
Location: Montreal, Canada
What I Drive: Ford Focus 06 ZX4 SE GFX + 2002 SVT

Posts: 47
FF Reputation: 1 flaurencelle Good Standing Member
Buy-Sell-Trade Rating: (3)
Ya, I did replace both upper engine mounts from Steve @ Tousley, made a difference for bad vibrations, more specifically, the passenger side one. The driver one, rarely goes bad...

I also checked if something else was knocking around by removing the engine mount bolt and rocking the engine forward and back by hand and the engine rocks free..nothing in the way..!

Also, I've tried putting a jack under the tranny while the torque mount was unbolted and the "Bang" is gone...I just hear it through the jack! So very likely the mount is shot...

I don't know if I should buy another rubber one or go with the Poly one..

I don't like vibrations too much, I had poly upper mounts and my teeth were falling..!

Anyone else has a clue?

Thanks a lot!
flaurencelle is offline  
    Reply With Quote