Originally Posted by dbenney
ok... ill take another look. I jsut looked through the manual today when there were a few things i couldnt figure out, and dont remember seeing it.
From page 164 on version 5 of the owners manual:
"Unlocking the doors/two-stage unlock
1. Press and release to unlock the driver’s door.
Note: The interior lamps and turn signal lamps will illuminate.
2. Press and release again within three seconds to unlock all the
doors. The turn signals will flash.
The remote entry system activates the illuminated entry feature; this
feature turns on the lamps for 25 seconds or until the ignition is turned
Two-stage unlocking may be disabled or enabled by simultaneously
pressing the and controls on the transmitter for four seconds
(disabling two stage unlock allows all vehicle doors to unlock
simultaneously). The turn signal lamps will illuminate twice to indicate
that two-stage unlock was enabled or disabled.
The unlocking mode will
be applied to remote entry, keyless entry and intelligent access (if
Two-stage unlocking may also be disabled or enabled through the
message center if this is an available message center option or by your
authorized dealer. Refer to Message center in the Instrument Cluster
If equipped with an IA key, when two-stage unlocking is disabled,
intelligent access at the driver’s door results in an unlock of all doors
(not just the driver door)."