Focus Fanatics - View Single Post - intake manifold butterfly flap issues
View Single Post
Old 08-28-2012, 10:42 PM   #1
WSkobra
Focus Enthusiast
 
Join Date: Jan 2012
Fan#: 93397
Location: Surprise, AZ
What I Drive: 2007 Focus SE 4dr Dark Shadow Gray

Posts: 103
FF Reputation: 1 WSkobra Good Standing Member
Buy-Sell-Trade Rating: (0)
intake manifold butterfly flap issues

I did some research on the dtec focus about compression ratios and came across an article that stated that there is a major fault in the materials of the plastic manifold. Apparently the butterfly flaps will eventually break out and get sucked into the motor and destroy the motor. Was wondering if anyone has had this issue. I am trying to find a way to stick this issue on Ford if this is a known problem on our motors. Mazda had the same issue with the manifold on their Mazda 3. Yet Mazda and Ford shared the same technology on these motors which included the manifold and Mazda put a recall out for it but Ford won't. If you had this issue let's hear what you have to say about it.


WSkobra is offline  
    Reply With Quote