Ford Focus Forum, Ford Focus ST Forum - View Single Post - Zetec Turbo Build: 230-250whp, then 330+whp
View Single Post
Old 08-22-2012, 03:06 PM   #528
starfuryt550
I Speed Often.
 
starfuryt550's Avatar
 
Join Date: Jan 2005
Fan#: 18440
Location: Plymouth,, MI
What I Drive: Audi S4, Turbo ZX3

Posts: 4,173
Points 21,264, Level 91
Points: 21,264, Level: 91 Points: 21,264, Level: 91 Points: 21,264, Level: 91
Level Up 83% Completed
Level up: 83% Level up: 83% Level up: 83%
Forum Activity 38%
Activity: 38% Activity: 38% Activity: 38%
FF Reputation: 23 starfuryt550 Great Standing Member
Buy-Sell-Trade Rating: (57)
Got some fittings in yesterday that I needed, hopefully it's all of them!

The stainless one is for a coolant hose, the rest are all for the distribution of the coolant lines.
The junction I made will run along side the block by the coil pack and allow the use of the oil temp and pressure sensors to be easily accessible!





....and I looked up how the temp sensor is...it's too deep and you can't use those standard 1/8" sensor fittings for the temp senders. Lame.
So what I will do is disconnect the union in the middle from the -6an to -6an, connect that to: -6an female / 1/8" male >> 1/8" inner thread 3" inner through-frame adapter >> 1/8" sensor sender.

That'll take care of this ish and the sender will have the clearance in there for a proper reading haha.

Here is that piece:

__________________
Daily: Audi S4 b5 | Project: Turbo ZX3
LED Conversions | Vinyl Carbon Wrapping | Powdercoated Valve Covers

Last edited by starfuryt550; 08-22-2012 at 05:11 PM.
starfuryt550 is offline  
    Reply With Quote