Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - CFM Intake boots- Warning/tip
View Single Post
Old 08-16-2012, 10:48 AM   #6
TommyTooHi
Focus Enthusiast
 
TommyTooHi's Avatar
 
Join Date: Oct 2011
Fan#: 90859
Location: Seattle, WA
What I Drive: 2004 Red Focus SVT

Posts: 198
FF Reputation: 1 TommyTooHi Good Standing Member
Buy-Sell-Trade Rating: (0)
yup yup and yup

Quote:
Originally Posted by BigRed03 View Post
havent had an issue since i put them on in 2009....

you sure the boot and/or clamps are seated properly when you install?? Did you pull the fuel rail to get the most access? I remember getting the #4 cyl (drivers side) on last and it was the most difficult. the bottom edge didnt want to go around the upper intake (part not attached to head). I put the couplers on the head side first, tightened those clamps and then started with #1 and worked my way across.
yup, and everything was snugged up tight, even new o-rings on the injectors for piece of mind...
I know it sounds like I moofed somewhere, but it's pretty easy to tighten hose clamps.

-T_T
__________________
Aw, heck - you mean what I know...

Mods: Caffeinated nut behind the steering wheel
TommyTooHi is offline  
    Reply With Quote