|
Here's the problem with PRYING the bezels out from the front....
What holds them in is thin little U tabs formed into the bumper cover that snap into those slots in the bezel. If you don't release the tabs the correct way, you just rip the U in half by pulling them out through the front. Then you run the risk of them not snapping back into place correctly, because the tabs are broken.
__________________
Sal
2012 Race Red 5-door SE, 18" Ti wheels, Ti headlights/fog bezels, 20% tint, debadged trunk
2002 Sonic Blue SVT - supercharged (sold)
2008 Vista Blue SE (gone)
|