Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - rebuild options
Thread: rebuild options
View Single Post
Old 07-20-2012, 02:45 AM   #1
burke_024
Focus Enthusiast
 
burke_024's Avatar
 
Join Date: Jan 2012
Fan#: 94039
Location: chehalis, WA
What I Drive: 2000 focus zx3, almost boosted : )

Posts: 272
Points 1,562, Level 22
Points: 1,562, Level: 22 Points: 1,562, Level: 22 Points: 1,562, Level: 22
Level Up 62% Completed
Level up: 62% Level up: 62% Level up: 62%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 1 burke_024 Good Standing Member
Buy-Sell-Trade Rating: (0)
rebuild options

so i have forged pistons and rods and they are starting to slap i wanted to know what my rebuild options are can i reuse the setup with a differant block and new bearings or do i HAVE to get over sized pistons ,im just assuming its been honed once when the rods and pistons were done ,just a rough ballpark estimate and what i would need ,and the most realistic block to use ,thnx


burke_024 is offline  
    Reply With Quote